Install ASIO4ALL if you haven't already.Install LoopBe1 if you haven't already.You only need the single 'VB-CABLE Driver' version, not the 'hi-fi' one. Install VB-CABLE if you haven't already.The exact MIDI and audio options in your instrument or plugin host might have different names from what you see in the pictures. The instrument I recorded while making the screenshots below was the standalone version of Native Instruments Maschine Software Required: VB-CABLE, LoopBe1, ASIO4ALL, SampleRobot (Pro or Sampling Suite recommended).Sometimes audio stops working, requiring system restarts. May involve some trial-and-error getting reliable results. Only worthwhile on SampleRobot Pro or Sampling Suite (the other editions are limited to 16-bit recording).

Disadvantages: Lots of steps to set up (and following proper sequence of steps is important).Advantages: Enables recording at higher bit depths than using Windows audio directly.If you accidentally do something out of sequence and you find you're not able to get audio to record, you might have to reboot your computer (or at least restart your applications) and try again.

Some of these steps have to be performed in a certain order. While complex, this method enables you to record into SampleRobot at a higher bit-depth than using a virtual audio cable directly. Method Two of Four: Virtual Audio Cable with ASIO Make sure to check out Part 1 for the introduction. Equalizer APO might do it, and perhaps Voicemeeter (works with VB-Cable).This is Part 3 of a 6-part series. Look into Virtual Audio Cable (VAC) and VB-Cable to send application audio to a compressor or limiter.

Is there any software that allows you to set a hard decibel limit on your computer? Windows is unfortunately very annoying for this set up, but you can work with it.

There's also Breakaway Pipeline, which is based on VAC, but free.

Crackling trouble with Virtual Audio Cable setup - VB-audio (Reaper -> OBS -> Virtual Cable -> Discord) You could also try an alternative to VB cable.

OBS Virtual Cam - audio setup The OBS Studio Virtual Cam unfortunately does not support audio at all, so you have to use a so-called Virtual Audio Cable like or under Windows or under macOS and configure this one as your monitoring device in OBS Studio.

Deep Rock keeps putting me on open mic every time I join or restart lobby Try changing the input source to something that doesn't work (or you can use something like an empty output from Virtual Audio Cable).

Create a new virtual input driver For windows, the lazy approach would be to use something like this.

Virtual audio cable no trial